M-audio NRV10 Manuel d'utilisateur télécharger pdf (Page 20)

NRV10 User Guide

< Set the Phones Source switch (29) to Monitor

< Setting the Pre/Post-EQ switch (26) to Pre-EQ will send the NRV10’s input signals to the DAW before the

channel EQs. Setting it to Post-EQ will send the signals to the DAW after the EQ.

< Set your DAW Software Monitoring to on if you wish to hear the return of your tracks from your DAW.

Set it to off if you want to listen to the channel inputs.

Important:

When using this monitoring scheme, be careful not to create a feedback loop. When the Channel

Source switch (6) is in the FW (down) position, do not move the Pre/post-EQ switch (26) to the Post-EQ

(down) position. Doing so will send the post-EQ signal to the DAW, while returning the same signal to the mixer

before the EQ, resulting in an audible feedback loop, which can damage your hearing as well as your equipment.

Returning Tracks from Your DAW

After you’re done recording, select any of the NRV10’s outputs 1 through 8 as they appear in your DAW as the output

for each channel you wish to route to the NRV10. Move the Channel Source button (6) to the FW (down) position for

the input channel(s) you have routed to.

The Digital Effects Processor

he NRV10 gives you an integrated digital effect processor, offering 16 presets with 16 settings per preset, for a total of 256

possible effects. Use the Aux 2 send control to send input signal to the effects processor.

The following programs are available:

1. Short Room

2. Room

3. Small Hall

4. Large Hall

5. Short Plate

6. Vocal Plate

7. Cathedral

8. Gated Reverb

9. Mono Echo

10. Stereo Echo

11. Chorus Medium

12. Chorus Deep

13. Flange Medium

14. Echo + Vocal Plate

15. Chorus + Hall Reverb

16. Flange + Delay

1 2 ... 15 16 17 18 19 20 21 22 23 24 25

Pas de commentaire

M-audio NRV10 Manuel d'utilisateur Page 20