M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manuel d'utilisateur télécharger pdf (Page 39)

Hardware options for Pro Tools LE and M-Powered systems

Front Panel

At the far left there is a 1/4” headphone jack with an associated knob to control

the volume. To the right of this you will see the main Monitor volume control

and the Mix control that lets you balance between incoming source audio

being routed direct to the monitor outputs and audio from the computer

being routed to the monitor outputs.

Figure A4.23

Mbox 2.

TIP

Use the Mix control for zero latency monitoring of your source audio while

recording. With it somewhere in the middle you can hear both source

audio and audio from the computer.

Looking at the right-hand side of the front panel you will see the Input gain

controls along with associated indicator LEDs, source selection, and Pad buttons.

In the middle there is a very useful Mono button and a button to switch on the

48-volt ‘phantom’ power, which is needed if you want to connect condenser

microphones directly to Mbox 2’s microphone preampli ers.

Figure A4.24

Mbox 2 front panel.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 52 53

Pas de commentaire

M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manuel d'utilisateur Page 39