M-Audio RAD-050503 Manuel d'utilisateur télécharger pdf (Page 9)

113188-3 www.amdry.com 7

b. Drying Temperature  Programmable from 160° F to 200° F (71° C to 93° C,), in one-degree increments,

and preset at 160° F (71° C) for axial dryers.

c. Dryness Level  Programmable for FINISHING, DRY, AND EXTRA DRY.

d. Cool Down Time  Programmable from 0 to 99 minutes, in 1 minute increments.

e. Cool Down Temperature  Programmable from 70° F to 100° F (21° C to 38° C), in one-degree

increments.

f. Cycle Adjustment  Programmable from 0 to 99.

Timed (Manual) Cycle

a. The Phase 7 non-coin microprocessor controller (computer) can be programmed to reverse or not

reverse. This is done in the DRYER SETUP parameter.

b. Drying Time  Programmable from 0 to 99 minutes, in 1 minute increments.

c. Drying Temperature  Programmable from 100° F to 200° F (38° C to 93° C) in one-degree increments

for a radial dryer, and 100° F to 160° F (38° C to 71° C) in one-degree increments for an axial dryer.

d. Cool Down Time  Programmable from 0 to 99 minutes, in 1 minute increments.

e. Cool Down Temperature  Programmable from 70° F to 100° F (21° C to 38° C), in one-degree

increments.

f. The Spin Time can be programmed from 30-seconds to 120-seconds, in 1-second increments.

g. The Dwell (Stop) Time can be programmed from 5-seconds to 10-seconds, in 1-second increments.

h. Steam Injection (Optional)  Programmable 0-5 intervals.

ALL six (6) A-F preprogrammed cycles, along with cycles 0-40, have been programmed by the

factory as outlined in Section VII. However, even though cycles A-F are the most common cycles

used, they should be reviewed to ensure they meet the location application or needs. Should changes

become necessary, refer to the Programming Section of this manual.

B. MANUALLY LOADED CYCLES

For occasional or onetime special loads, the operator must enter the specific program features needed. This

cycle is not stored within the Phase 7 non-coin microprocessor controller (computer) and must be entered each

time.

The Manually Loaded Cycle can be set in either the Automatic Drying Mode (Patent No. 4,827,627) or the

Timed (Manual) Drying Mode. These modes are selected by pressing the AUTO or MAN key on the

keyboard (touch pad).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 89 90

Pas de commentaire

M-Audio RAD-050503 Manuel d'utilisateur Page 9